12 Days of Christmas DIY Giveaway Day 4: Burlap Rose Wreath!
***UPDATE: This giveaway is now closed. Congrats to Briana! Thanks for entering everyone. Be sure you enter all the other giveaways that are live while you still can!***
What’s a 12 Days of Christmas DIY Giveaway without at least 1 wreath. If you remember a week or so ago, I posted about the Christmas Tea Table I did for our church’s Lottie Moon Christmas Offering Fucnction, well full disclosure, I just used some of the roses I made for that event for this wreath. But Fear not, I’ll show you how I got there.
First grab your supplies:
For the roses I cut 3½” wide strips of burlap from selvage to selvage (across the full width of the burlap). I took that strip and cut it in half so that I had two equal strips. To keep the strips from fraying while being twisted and rolled, I folded the strip in half (hot dog style) and ran it through my sewing machine using a zig zag stitch with red thread. This makes the burlap super manageable and you’ll never see the thread.
Start your flower just like you would any other flower start rolling one end in on it self to give your flower a “bud” like center. Now start twisting your strip and rolling it around the center of your flower, placing a dot of hot glue as you work your way around to secure it in place.
Now, onto the wreath itself. I got the form the Dollar Tree and had it and a few others in my craft stockpile.
To cover the wreath form, I used about 53″-54″ of Jute Webbing. You can find this is the rug section of Joann Fabrics as well as a number of places online. I think it’s only something like $0.79/yd. Don’t forget your coupon!
Now, because of how wide the webbing is, it can be tricky to cover the form without a whole lot of overlap and bulges. The trick here is to wrap it at such a “steep” angle that it looks like you’re trying to wrap from the center to the side of the form instead of the the center to the outside just below. When you’re all done, flip the extra bit over so that your edge will be well hidden in the back of the wreath. I only glued the beginning edge of my strip and then again at the end. This way if there is need for adjustment somewhere in the middle, you’re not “stuck” (ha ha, oh Michelle!), just twist it like you would ring out a towel.
Give that strip a good amount of hot glue and hold down firmly until the glue cools. You want it to be secure.
An extra strip of burlap with edges sewn so it would fray acted as my ribbon to hang the wreath from.
Festive, Cheap and Easy. My kinda craft.
Don’t forget to enter today’s Giveaway or yesterdays too while you’re at it!
a Rafflecopter giveaway